OneKey hardware wallet firmware upgrade tutorial

★Be sure to save your mnemonic phrase. The firmware will be overwritten during the upgrade process, which may cause data loss. Please make sure you have the corresponding mnemonic phrase on hand.

First, make the OneKey hardware device enter the BootLoader mode — press and hold the shutdown button and the down button at the same time and do not release it until the screen displays power on..., release the power button at this time, and the hardware device enters the BootLoader mode .

9-09.jpg

Then open the official OneKey firmware upgrade website https://firmware.onekey.so and use the data cable to connect the hardware device to the computer.

The first time you use OneKey Bridge, you must download and install the appropriate operating system (supports Win/Mac/Linux).

● Because the data cable that comes with the Mac is unable to transport data between the computer and the hardware wallet, the conversion head must be used.

●If you don't see the matching system, press "ctrl+"-" to find the equivalent system:

onekey-bridge-2.0.33-1.i386.rpm (Linux 32-bit (rpm))
onekey-bridge-2.0.33-1.x86_64.rpm (Linux 64-bit (rpm))
onekey-bridge-2.0.33-win32-install.exe (windows system users, 32-bit, 64-bit both use this installer)
onekey-bridge-2.0.33.pkg (OSX system users)
onekey-bridge_2.0.33_amd64.deb (Linux 64-bit (deb))
onekey-bridge_2.0.33_i386.deb (Linux 32-bit (deb))

Screen_Shot_2021-07-29_at_10.31.06_PM.png

Mac need in System Preferences - Security and Privacy - General select Open Anyway

mac.png

Setting up the OneKey Bridge

If users receive the following error notice due to system differences, detach the hardware from the computer first, then continue the installation.

__bridge___.png

After Bridge is installed, disconnect the hardware device from the computer, and then connect the hardware device in BootLoader mode to the computer again. Click Continue to enter the firmware installation page.

1.png

Confirm the firmware version and select Install . The upgrade process may cause data loss, please make sure your mnemonic phrase has been properly saved. (For Bluetooth firmware upgrade, select the Bluetooth firmware on this page to install and upgrade.)

2.png

During the firmware installation process, you need to confirm on the hardware device.

3.png

Enter the following page, the firmware upgrade is successful, and you can use it normally.

4.png

The above is the OneKey hardware device firmware upgrade tutorial. 

 

Was this article helpful?
0 out of 0 found this helpful